THE HYBRID 100V POWDER DIARIES

The hybrid 100v powder Diaries

The hybrid 100v powder Diaries

Blog Article

It is the most effective powder I have found for velocity without having force signs in my 284 win. Ought to be a great option for the 6mm or 257R. Edited to incorporate this is Along with the medium to heavier bullets - one hundred forty-a hundred and sixty gr.

Am i accomplishing a thing Completely wrong in this article? any tips or solutions would be very good. I know i could utilize a magnum primer but i have 3k benchrest primers so i really dont need to invest in any more. Click to broaden...

Its dependable ignition, small standard deviations, and temperature security offer shooters with the sting they need to excel in hard environments.

I happen to be Doing work up hundreds considering the fact that Jan. a year back with a Kimber 84M in 257 Roberts and arrived on 100V along with the promise of larger velocities at reduced pressures. I started to chrony the one grain above min. as quoted within the Hodgdon manual. To start with two velocities have been wherever I predicted them being per the book and also the third was much too but I couldn't receive the bolt open up to save lots of my lifestyle. I took the rifle home and took a scrap 2x2 and tapped the bolt up and then began to get it to move back again when Abruptly the bolt pinged through the garage. Well now I used to be in deep schite. I boxed in up and despatched it to Kimber. I sure wasn't executing anymore superior for it so sent it for the authorities.

There is a forty eight lb most of powder allowed per HazMat charge, even so, in the event you buy powder and primers alongside one another under 1 HazMat payment, you might have 70 lb max for each get, of which no more than forty eight lbs may be powder. Primers & powder can not be returned. Look at nearby hybrid 100v rules.

The gap from chrono to muzzle is about 10 ft. I didn't have a tape evaluate but applied methods so it was inside of 1-two ft at one of the most. I just forgot the tape measure is all. Really should I be putting it additional than that?

I basically established my chrony 15-20 ft in front of the muzzle after which I do know I am not having any outcomes from muzzle blast. I visit a ballistic calc. and set that variety up at the space of my chrony and obtain my correct muzzle vel.

I planned to use an Severe powder for that temp sensitive but i just am not receiving the velocity with them as I'm with the hybrid 100v.

My .300wm definitely likes H4831, with nickel sized three shot teams at 100yrds. I've also been getting good success with RL25, it unquestionably packs the situation. All of my testing has been completed with Hornady 180grn bullets.

I started off with H4350 and even though I have found right before while in the 300 gain mag H4350 does wonderful even with a hundred and eighty's I had been searching once more to make use of H4831sc but lately read about the Hybrid 100V.

The list of cartridges and bullets is restricted with this extremely specialised powder, but exactly where it really works, it hodgdon hybrid 100v truly will work!

The terrible a single was the second shot soon after lunch. It landed three/four inch from the 1st shot of that team. The only thing I'm able to figure would be that the scale received just a little Grime in/around the bearing(s).

I might get approximately 200 fps a lot more velocity with H100V when compared to H4350 in my 257s. However, they're our pronghorn rifles so temperature security will not be a difficulty for us.

I would like to get 3000fps out of my 280AI in a very 25in barrel with these parts. chime in if you bought another way (with applying hodgdon powders, i dont need to mess with hybrid 100v alliant)

Report this page